80
17. Reset and Initialization
17.1 Reset
Press and
hold
buttons the
buttons
A
and
A1
(A + A1 = R [reset]) resp.
buttons T 11 and T 12
of the relevant hand control (s. figure below)
simultaneously
for approx.
10 seconds
until the signal tone ends.
Then move the lifting column and the actuators as described below
(initialization).
HAND CONTROL
:
Lina Select Alu
MEMORY HAND CONTROL
:
Lina Select Wood / Static
NOTICE!
Previously saved memory values are deleted (except pre-
programmed memory positions)!
17.2 Initialization
❖
If a previously-saved position is no longer properly set, you may have to
initialise the software of the Lina Select.
To correct the differences of position, you must carry out the following steps:
I
NITIALISATION
L
INA SELECT ALU
The hand control of the L
INA SELECT ALU
must
be
in
LEVEL
1
operation (in
LEVEL
1
the LED above the
SHIFT BUTTON
is
off
).
1.
The
BACKREST ACTUATOR
must be set to its
max
. position.
The
BACKREST
must have an angle of approx. 70° to the seat!
Use
button B
of the relevant hand control / s. fig. below.