EN
Moreover, normal wear and
change in product with no functional influence
are not covered by the warranty. Also, be careful
that, if the usage in the instruction manual is not
observed as to the mixed gasoline, etc. descri-
bed therein, it may not be covered by the war-
ranty.
REFUELLING
Never smoke whilst refu-
elling and avoid inhaling the petrol fumes.
Carefully open the tank
top as pressure could have formed inside.
Before refuelling:
– Shake the fuel mixture container well.
– Place the machine on a flat stable surface,
with the fuel tank cap facing upwards.
– Clean the fuel tank cap and the surrounding
area to avoid any dirt from entering the tank
during refilling.
– Carefully open the fuel tank cap to allow the
pressure inside to decrease gradually. Use a
funnel to refill and avoid filling the tank to the
brim.
Always close the fuel tank
cap firmly.
!
WARNING!
!
WARNING!
!
DANGER!
IMPORTANT
Immediately clean all tra-
ces of fuel which may have dripped on the
machine or the ground and do not start the
engine until the petrol fumes have dissipated.
CHAIN LUBRICANT
Only use special oil for chain
saws or adhesive oil for chain saws. Do not use
oil containing impurities so as not to block the oil
filter and to prevent irreparable damage to the oil
pump.
The special oil for lubrica-
ting the chain is biodegradable. Use of a mineral
oil or engine oil causes serious damage to the
environment.
It is essential that you use good quality oil to
lubricate the cutting parts effectively. Used or
poor quality oil does not guarantee good lubri-
cation and reduces the duration of the chain and
bar.
It is always worth topping up the oil tank com-
pletely (using a funnel) every time you refuel.
Since the oil tank capacity is enough to guaran-
tee that the fuel runs out first, you will avoid the
risk of operating the machine without lubricant.
IMPORTANT
IMPORTANT
!
WARNING!
• To start the engine (Fig. 4):
– Continuously push the priming bulb (1) until
fuel comes in the bulb.
– Set the switch (2) to «I» position.
– Pull out the choke knob (3) to the second-sta-
ge position. The choke will close and the
throttle lever will then be set in the starting po-
sition.
When restarting immediate-
ly after stopping the engine, set the Choke knob
in the first-stage position (choke open and throt-
tle lever in the starting position).
NOTE
STARTING THE ENGINE
The engine must be start-
ed in an area at least 3 metres from where
you refilled the fuel tank.
Before starting the engine:
– Take off the bar cover.
– Make sure the bar is not touching the ground
or any other object.
– Fill fuel and chain oil tanks respectively, and
tighten the caps securely.
!
WARNING!
10
PREPARING TO WORK / HOW TO START - USE - STOP THE ENGINE
6. HOW TO START - USE - STOP THE ENGINE
