HOW TO CLEAN
Cleaners:
Never use harsh, abrasive cleaners, heavy-duty cleaners, or solvents on any surface.
Exterior:
Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for periodic waxing,
use silicon wax.
Freezer:
When unit needs defrosting turn thermostat to “OFF” (“0”). Do not use sharp metallic
instruments to scrap off ice/frost.
Refrigeration Section:
Wash shelves and other removable parts in warm sudsy water, rinse and dry.
Wash interior with baking soda solution (3 tablespoons to I liter of water) or warm sudsy
water, rinse and dry.
Magnetic Door Seals:
Wash with warm sudsy water.
The Finishing Touch:
Replace all parts and return thermostat dial to desired setting.
WARNING: Do not clean your unit with flammable fluids. The fumes can create a fire
hazard or explosion.
HOW TO INSTALL
WARNING
：
This unit is not designed for recessed installation.
Install freezer in a convenient location away from
extreme heat and cold. Allow sufficient clearance
between the freezer and sidewall so the door will open
without obstruction. This freezer is not designed for
recessed installation.
Select a space with strong level floor. Not
recommended for carpeting or other soft / uneven
surfaces.
Allow 10 cm of space between the unit and the
sidewall to keep good air circulation. In addition,
sufficient clearance (160°) should be maintained to
allow the door to open properly and completely.
The appliance must be correctly connected to the power supply, 220-240V~50Hz,with grounding
Do not use an extension cord.
WARNING: To avoid a hazard due to instability of the appliance, it must be placed at an even or flat
surface.
POWER CORD REPLACEMENT
If the freezer’s power cord is damaged, have it replaced by a qualified repair agent.
CARE AND MAINTENANCE
The freezer should be cleaned on a regular basis. (See: “HOW TO CLEAN”)
It is necessary to have an adequate ventilation space around the refrigerator in order to
attain proper performance, dissipation of heat, maintain efficiency, and low power consumption.
Clearance of minimum 10 centimeters should be maintained at the rear and sides of the unit and
20 cm at the top of the unit.
10cm
Содержание BD-32
Страница 10: ......
