Gfp 230 C
June 2012
19
17. Laminating
$ote: It is hard to remove film adhesive once it gets onto the rubber
rollers. When laminating, always use materials same width as the film
roll. If your sheets are narrower than the film roll, use a laminating sled
or Kraft paper roll on the bottom to keep the film adhesive from sticking
to the bottom machine rubber roller. Always use media roll the same
width or wider than the film supply roll.
To clean the rollers, use rubber eraser or Isopropyl Alcohol and a shop
towel.
17. A Single Sheets using a sled
•
Load a roll of laminating film on the top roller
( see loading film section 13)
•
Turn the pressure-adjusting hand-wheel to lift up the upper roller.
•
Select a piece of Gatorboard or other PVC mounting board the width
of the film web to use as a sled under the print to be laminated
•
Insert the sled between the nip rollers and lower the top roller until it
touches the sled
•
Reverse the motor to back the sled out of the rollers
•
Pass the film web under the idler bar and down in front of the roller
•
Separate 1” of the paper liner from the film web, attach film web to
a leader board the width of the film roll and insert leader board into
the rollers
•
Use foot pedal to advance the film web half way through the roller
and stop
•
Position print on the sled
•
Depress the foot switch and run sled through
•
Insert another leader board or next sled right behind the first sled
