GEZE Slimdrive EMD-F-IS, Оригинальная инструкция по эксплуатации

Страница: 6 / 20

Slimdrive EMD/EMD-F
6
Fundamental safety precautions
2 Fundamental safety precautions
For the user
Carefully read and abide by this user manual before commissioning the door. Always observe the following
safety instructions:
à
Operating, maintenance and repair conditions specified by GEZE must be observed.
à
The commissioning, mandatory installation, maintenance and repair work must be performed by experts
authorised by GEZE.
à
The connection to the mains voltage must be made by a professional electrician.
à No changes may be made to the system without prior agreement from GEZE.
à GEZE shall assume no liability for damage caused by unauthorised changes to the system.
à The owner is responsible for safe operation of the system.
à
Have a service technician check the safe operation of the system at regular intervals.
à
Should safety devices be misaligned, thus preventing them from fulfilling their intended purpose, further
operation is not permissible. The service technician must be informed without delay.
à
Make sure that the safety stickers are attached visibly to any glass leaves and are in a legible state.
à
Protect the programme switch against unauthorised access.
à
Danger of injury by sharp edges on the drive when removing the weather hood
à
Danger of injury by parts hanging down
à This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved.
à
Children shall not play with the appliance.
à
Cleaning and user maintenance shall not be made by children without supervision.
For the service technician
à GEZE does not accept any warranty for combinations with third-party products.
à Only combine third-party products with original parts following agreement by GEZE. Furthermore, only origi-
nal GEZE parts may be used for repair and maintenance work.
à
The power connection and protective earth conductor test must be carried out in accordance DIN VDE 0100-610.
à
Use an on-site automatic cut-out as the line-side disconnecting device, the dimensioning of which is matched
to the type, cross-section, type of routing and ambient conditions of the on-site power supply circuit. The
automatic cut-out must have at least 4 A and max. 16 A.