GEZE E-ISM, Инструкция по установке

Страница: 12 / 24

E-ISM Boxer
Mounting and securing
6.4 Positioning the trigger unit
Fig.: 6.4.1
X
Release the fixing screws of the release trigger by about 1/2 turn ( 1. ).
X
Connect the sliding lever with the sliding pad of the fixed leaf ( 2. ) (tightening torque: 5 Nm).
X
Open the closing time valve „1“ at the Boxer fixed leaf ( 3. ).
X
Close the fixed leaf (release trigger will be positioned) ( 4. ).
CAUTION
When closing, make sure that no cable or steel wire gets wedged in the gap.
X
Re-open the fixed leaf ( 5. ).
X
Keep the fixed leaf open ( 6. ).
X
Insert the fixing screws of the release trigger and tighten max. 45° ( 7. ) (tightening torque: 0,4 Nm).
6.5 Connect the steel wire to the release trigger
X
Thread the steel wire into the funnel and pull it out at the deflection pulley ( 1. ) .
X
Engage the release slide ( 2. ) .
X
Release the clamping screw ( 3. ).
X
Push the steel wire through the clamping device ( 4. ).
X
Tighten the steel wire ( 5. ).
X
Lightly tighten the clamping screw ( 6. ).
X
Cut back the steel wire to a length of about 50 mm ( 7. ).
X
Clip the end cap onto the guide rail of the secondary leaf ( 8. ).
Fig.: 6.5.1
GB 5