Gewiss GW 10 793, Руководство пользователя

Страница: 44 / 164

During operation, the activation of. the heating or air-conditioning functions are indicated
as followed:
Heating
The symbol indicates that the activation command has
been sent to the actuator which controls the boiler or the
zone electrovalve. If the load notice has been sent via the
ETS and the thermostat does not receive confirmation from
the actuator that the same has been activated, the
symbol starts to flash. Subsequently, the thermostat sends
the activation command again, at one minute intervals, until
it receives a positive response.
Air conditioning
The symbol indicates that the activation command has
been sent to the actuator which controls the air-conditioner
or the zone electrovalve. If the load notice has been sent via
the ETS and the thermostat does not receive confirmation
from the actuator that the same has been activated, the
symbol starts to flash. Subsequently, the thermostat sends
the activation command again, at one minute intervals, until
it receives a positive response.
Operation with fan-coil control activated
The symbol appears on the display if the fan-coil control
is activated in the parameter settings.
Press the FAN key repeatedly to adjust the fan-coil speed
or set the AUTO mode option, where the fan-coil speed is
automatically regulated according to the difference between
the set-point set on the device and the current temperature.
The fan coil speed indicator flashes when the fan is running.
To set the thermostat parameters, press the SET key.
The word SET appears on the display and the symbol of the set operation type (heating
or air-conditioning) starts to flash.
OPERATING INSTRUCTIONS
44
Setting parameters