START TO OPERATE:
Fill water into the water tank NOT exceed the MAX line. Set
up the water tank vertically and align the buckles to the
hole on the back of the machine, and press it down to be
parallel to the top of the machine.
(If you had operated the
machine just now,skip this step)
NOTE:
When the water tank is pulled up, the water will
flow out from the outlet at the bottom of the water tank,
which is a movable part. If you have not wipe the water
immediately, it will accumulate more and more and ran to
the bottom of the machine, leaving the table full of water.
Plug in the power cord, press down the power switch to
“I” position, the coffee switch light will flash blue, and the
default setting is brewing espresso.
(If you had operated
the machine just now,skip this step)
Place 2-cup mesh inside the portafilter, make sure the
tube on the mesh aligns with groove in the portafilter. To
achieve a full flavor, 7g coffee powder is best for one cup
of espresso.To avoid leaking, coffee powder should be
tamped BELOW the MAX line of portafilter. But powder
could not be tamped too firmly otherwise the coffee will
not flow out smoothly.
1.
2.
3.
Faced up the portafilter, then installed in parallel to the
machine from "Insert" to "Lock" in placed, otherwise the
coffee will splash and leak from the gap of the connection
position.
When the coffee switch light stop flashing(the knob is on
the " " position) , it shows the heating is finished. Never
skip to step 6 before the coffee switch light has been
illuminated. As if the temperature is not suitable for
making espresso, it will effect the coffee taste.
Place a cup on the drip tray.Turn the knob to the far side
“ ”.If the cup is tall, you can remove the drip tray cover
and put the cup into the drip tray.
NOTE:
1. When the machine starts to work, there will be some
noise out from the machine as it is pumping the water
with a high pressure.
2. While during operation , if there is suddenly a loud noise
from the machine, which may due to the water in the
water tank is not enough for pumping.
3. When the water left the boiler is going to finished, it will
produce a louder noise. After adding water, it will operate
as usual.
4.
5.
6.
