GEV FlammEx FMF 3545, Руководство пользователя, Страница: 11 / 20

10 11
GB
FR
IT
DE
Note: Maintain a minimum distance of one metre between
the radio modules, even during installation.
Creating a radio group
At any one time, activate only the two radio modules that are
to be programmed and not every module simultaneously. Hold
down the button (Fig. 1.2) on a radio module for approximately
2–3 seconds. The red LED (Fig. 1.1) then begins to flash
approximately once every second. Release the button again.
The radio module enters programming mode for approximately
60 seconds. After this period, immediately press the button (Fig.
1.2) on another radio module for approximately 2–3 seconds.
The red LED (Fig. 1.1) then begins to flash approximately once
every second. Release the button again. The radio module enters
programming mode for approximately 60 seconds. During this
time, both radio modules reciprocally program themselves into
a radio group automatically. The programming process can take
up to approximately 60 seconds in total. If programming was
successful, the red LEDs (Fig. 1.1) on both radio modules light up
permanently for 2–3 seconds. If after approximately 60 seconds
the red LEDs do not light up permanently for 2–3 seconds,
the programming process was not successful and the radios
modules return to normal mode. In this event, the programming
process must be repeated. Up to 30 radio modules can be
assigned to a radio group.
Expanding an existing radio group
At any one time, activate only the two radio modules that are
to be programmed and not every module simultaneously. To
expand an existing radio group, switch any radio module from
the radio group to be expanded to the programming mode
by holding down the button (Fig 1.2) for approximately 2–3
seconds. For the other radio modules, do not plug the three-
pin terminals of the radio modules (Fig. 1.3) onto the detector.
The red LED (Fig. 1.1) then begins to flash approximately once
every second. Release the button again. The radio module
enters programming mode for approximately 60 seconds. After
this period, immediately press the button of the radio module
to be added for approximately 2–3 seconds. The red LED then
begins to flash approximately once every second. Release the
button again. The radio module enters programming mode
for approximately 60 seconds. During this time, the radio
module to be added will be automatically incorporated into the
existing radio group. The programming process can take up to
approximately 60 seconds in total.
Creating an additional radio group
At any one time, activate only the two radio modules that are to be
programmed and not every module simultaneously. Proceed in
the same manner as described in the section entitled „Creating a
radio group“. Program only the radio modules to be incorporated
into the additional radio group. During this process, do not
integrate a radio module that is already assigned to another
radio group. It is possible to create up to eight independent radio
groups.
Note: The button (Fig. 1.2) is locked for five minutes after
being activating. This also applies for the radio modules
that have received the test radio message.
Deleting programmed settings/factory setting
Press and hold down the button (Fig. 1.2) on the radio module
that you want to delete for approx. 5 seconds until the red LED
(Fig. 1.1) starts flashing approx. twice per second. When you
have held the button down for approx. 2-3 seconds, it will initially
start flashing approx. once per second. Continue to hold down
the button until the LED starts flashing twice as fast. Release the
button. The radio module confirms deletion by emitting a short
beep and then returns to standard mode. However, the device
does not belong to a radio group.
BA_3545_MA00822802_04062018_DIN_A6.indd 11 06.06.2018 12:16:03