Geutebruck 5.04720, Руководство по установке

Страница: 10 / 25

10
2. Camera Cabling
Please follow the instructions below to complete the cable connections.
NOTE: This camera must be installed by qualified personnel and the installation should
conform to all local codes.
2.1. Power Connection
For power connection, please refer to section Connectors for the Indoor models, and see section All
in One Cable for the Outdoor models. Alternatively, users can power the camera by PoE if a Power
Sourcing Equipment (PSE) switch is available. Refer to the section below for Ethernet cable
connection.
NOTE: If the device is powered over Ethernet, make sure the PSE is connected to the
network.
2.2. Ethernet Cable Connection
To have best transmission quality, cable length shall not exceed 100 meters. Connect one end of the
Ethernet cable to the RJ-45 connector of the camera and plug the other end of the cable to the
network switch or PC.
NOTE: In some cases, Ethernet crossover cable might be needed when connecting the
camera directly to the PC.
Check the status of the link indicator and the activity indicator LEDs. If the LEDs are unlit, please
check the LAN connection.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
2.3. Connect Alarm I/O
The camera supports one alarm input and one relay output for alarm application. Refer to section
Connectors for pin definitions.
NOTE: Do NOT connect external power supply to the alarm I/O connector of the IP
camera.