3
2.0 - INSTALLATION AND CONNECTIONS
WARNINGS:
- Complete a pre-installation check and disconnect the negative terminal of the vehicle’s
battery. .
- Before fixing the device, insert the installation loom connectors into the alarm and
screw the connector cover on.
- Place the alarm system in the engine compartment, away from direct sources of
water spray and high tension wiring.
- Solder and isolate all connections.
-
Connect the
BROWN
wire to the negative terminal of the vehicle’s battery (power supply
negative).
-
Connect the
RED
(general power supply) and
RED/WHITE
wires (indicator relay positive)
to the positive terminal of the vehicle’s battery with a 15A fuse.
-
Connect the
YELLOW
wire to an ignition switched live (+15/54) that remains live even
when the engine is being cranked.
-
ORANGE
wire (INDICATOR Command): if the INDICATOR COMMAND is
DISABLED
connect to the vehicle right indicators (or to the left). If the INDICATOR COMMAND function
is
ENABLED
with this wire is possible to command the indicators (only on the vehicles
equipped with this function - See the INDICATOR COMMAND diagram). For the connection
refer to the technical installation guides.
-
Connect the
ORANGE/BLACK
/wire (FEEDBACK) to the vehicle left (or right) indicator by
a diode(2 Amp) (see the INDICATOR COMMAND diagram).
-
Connect the
GREEN
wire to the switches for the boot and bonnet protection.
-
Connect the
GREEN/BROWN
wire to the original door pin switches. This alarm input is
set by default to manage the negative stable signals. It is possible to manage also the
vehicles original switches with negative impulsive signals(pulsing) enabling the Function
No.6 PULSING management. For the connection refer to the technical installation guides.
It is possible to manage also the positive stable signals enabling the Function No.7
Postive Door pin switch management.
-
Connect the
PINK
wire (Positive output when the alarm is armed - Max capacity 80 mA to
the PINK wire of modules or additional sensors (i.e. ultrasonic module).
-
Connect the
GREEN/BLACK
wire (alarm input by optional additional sensors) to the
GREEN/BLACK wire of the same (i.e. ultrasonic module).
-
Connect the
BROWN
wire
(Sec. 0,35mm²)
to the modules or additional sensors (i.e.
ultrasonic module).
-
The
RED/BROWN, RED/GREY, RED/BLUE, YELLOW/BROWN, YELLOW/GREY and YELLOW/
BLUE
wires are used to command the central door locking referring to the instuctions in
the technical installation guide.
WARNING:
- Always use 5 A fuses on the RED/BLUE and YELLOW/BLUE wires.
- The max. load to command the central door locking is 5 A. For example it is not
possible to drive directly No.4 GT71 actuators (see diagramNo. 5).