Getinge S-406, Руководство по установке

Страница: 10 / 24

10
Flusher disinfector S-406 Installation
9904
• Press
5
when you have finished. The display window will then go ’OFF’
for a short period (the new value is stored in the machine memory) and then
the new value will be displayed with a steady light.
If you change your mind before pressing ’Completed’, you can press
4
. The
old value will then be reset again.
• Press
5
once again to quit the line and enter the line number. Go to the
next line that is to be changed.
• Press
4
for three seconds to quit the service program.
The machine is now ready for operation.
Setting the amount of cleaning and deliming agents on pumps
by means of adjusting screw
The disinfector may be supplied with three different dosage systems: two for
detergent dosage and one for descaling compound. For descaling and spray
dosage the amount of compound can be set in the service program (see
Illustration 8).
Set by the service program
Fig. 8. Dosage pumps
• Measure out 100 ml of detergent into a measuring glass. Check that the
suction pipe and pump are full of detergent before carrying out the check.
• Insert the suction pipe into the measuring glass and run a washing program.
Remove the suction pipe and read off consumption. Adjust if necessary in the
service program and repeat measurement until the amount is correct
according to manufacturer’s recommendations.
Detergent pump
(spray)
40 ml
Detergent pump
50 ml
V071
Deliming pump
6 - 10 dH° 1,5 ml
10 - 15 dH° 3,0 ml
15 - 20 dH° 4,5 ml
V304
V583
May only be performed by authorized personnel.
This machine is connected to mains power supply and some
components are live.