Page 13 of 24
<Doc_USR><Doc_5025919000><Rel_A><Lang_EN>
If necessary
The spray arm
Clean the spray arms when necessary by unscrewing the central nut, lifting off the spray
arm and rinsing it until it is clean. Take off the plastic end pieces by pressing the metal
bar over the edge of the spray arm and removing them. Using a washing brush, clean the
inside of the spray arm.
After cleaning, press the metal bar back into the groove in the plastic end piece.
Check that the arm can rotate freely when re-installed.
Washing chamber
Do not allow deposits to form in the wash chamber. Remove any deposits as follows:
Open the door and dispense 200 ml NEODISHER BU descaler (sold by
•
Dr. Weigert) into the washing chamber.
Close the door and run the descaling program.
•
NOTE: There must not be any items in the machine with this program. It is only used to
descale the machine and insert.
The outside
The front and side walls can be cleaned and disinfected with an alcohol-based cleaning
agent, medical spirit or an ordinary cleaner. The control panel can be cleaned in the same
way. To remove stains, use ordinary stainless steel cleaner.
If the washer disinfector is used without automatic descaling for incoming water, the
heating element must be checked regularly for limescale deposits.
It is important to maintain a good level of hygiene around the machine.
V1627
V2026
V2027
