GETINGE GROUP ARJOHUNTLEIGH Bari-Breeze, Инструкция по эксплуатации

Страница: 20 / 168

11
6. Operation
Before using the
Bari-Breeze
mattress system, make sure it has been installed
correctly in accordance with “Installation and Setup” on page 6, and ensure that the
side bolster and base plug is secure in the connector at the foot end of the mattress.
Initial Power Up
Press the power/standby button to turn the pump on. An
audible beep will sound. The system will go into a start
up cycle for 30 seconds, during this time the pump will
rapidly inflate the mattress. During this process the 7
segment display will alternate between ‘
b
’ and ‘
f
’ to
indicate bolster fill.

These may reflect the therapy settings that were applied last time the system
was in use.
Comfort Controls
Once the mattress is fully inflated and with the patient in
position, adjust the comfort controls to the desired level.
Adjust if neccesary to ensure that the patient does not
sink through to the base air pad.
Recommended Pressure Settings
For extra firm support during patient handling or nursing
procedures, it is recommended to set the mattress
pressure to maximum by pressing
MAX FLOW (
).
When the patient is to be placed in the gatched position,
it is recommended to press the button to
increase
the pressure/comfort level accordingly. to ensure the
patient does not bottom out.
Static Mode
Max Flow
Pressing the button sets the blower to maximum
flow, fully inflating the mattress overriding the comfort
control. This feature is only available in static mode. If
pressed during
Turn
mode, it will revert the system to
Static
mode and return the patient to a central position.
Max Flow
inflates the mattress to maximum pressure for
15 minutes, and this will be indicated by a blue LED and
an ‘
F
’ being shown in the LED display.
To cancel
Max Flow
and to enter
Turn
mode settings,
press the button once. To continue
Max Flow
for
more than 15 minutes, press once to cancel, and
quickly again to enter
Max Flow
for a further 15 minutes.
After 15 minutes,
Max Flow
is automatically cancelled.