Fan Mode (LED illuminates Green)
Air is cooled and circulated throughout the room. Note:- It is not necessary for the vent hose
to exhaust outside the room.
SPEED
This button is used to set the fan speed to Low, Medium or High. Note:- fan speed can not be
altered when in Dehumidifying mode unless the room temperature is above 25°C
Setting the Temperature
The temperature can be set by means of the
▲
UP and
▼
DOWN buttons on the remote
controller. Note:- It is only possible to set the temperature when in COOLING MODE.
The temperature can not be set when in DEHUMIDIFYING or FAN mode.
The temperature can be set between 16°C and 32°C and the temperature set will remain in
the Temperature / Time Display Window for approximately 5 seconds. The display will then
revert back to showing the current room temperature.
When the room temperature is higher than the display range, the display will show “HI”.
When the room temperature is lower than the display range, the display will show “LO”.
Setting the Timer
Press the Timer button on the remote controller to set the timer. The Temperature / Time
Display Window will flash for approximately 5 seconds and show the time that was last set on
the timer.
While the display is flashing, press the
▲
UP and
▼
DOWN buttons on the remote controller to
select the time (in hours, between 00 and 24) for either of the timer modes “a” or “b” as
detailed below. The time selected will be shown on the display panel and after approximately
5 seconds the display will revert to showing the room temperature.
Timer mode a) Auto Turn Off
:- With the machine on and running, set the timer to select the
number of hours you would like the unit to run until it automatically shuts off.
Timer mode b) Auto Turn On
:- Switch the machine on using the ON / OFF button (either
on the machine itself or on the remote controller) so that the machine is running and the
desired mode is selected. Press the ON / OFF button again to put the machine into stand-by
mode. Set the timer to select the number of hours until it is required for the machine to start
up automatically.
CANCEL Button
If the time has been set as in either “a” or “b” above and it is then decided that the timer is not
required, pressing the CANCEL button will turn the timer off.
°C / °F Button
Pressing this button will switch the display between degrees Celsius and degrees Fahrenheit.
IMPORTANT
When the appliance is in Cool or Dehumidifier mode, most moisture will be vented out
through the vent pipe. However, in certain circumstances some condensation may collect in
the water tank at the bottom of the chassis. When this tank is full, the “Tank full” indicator
(marked ALARM) will illuminate (red) and the appliance will stop running. The appliance
should then be unplugged from the supply socket and the rubber plug in drain port at the
lower rear
of the machine should be pulled out to drain the water into a suitable container.
Alternatively, move the appliance to a suitable place to drain the water.
Note: When the Tank Full light (marked ALARM) is on, the
water should be drained out. If the water is not drained out,
the appliance will not operate.
