Timer
Press the Timer button to set the timer. The green LED next to the ON/OFF legend will flash on and off for
15 seconds.
While the green LED is flashing, press the timer/temp adjust buttons (
▲▼
) to select the time (in hours,
between 00 and 24) for either of the timer modes “a” or “b” as detailed below. The time selected is shown on
the display panel. After the 15 seconds the display will revert to showing the room temperature.
If no time has been selected the timer will be off and the green LED will not be illuminated.
Timer mode a) Auto Turn Off
:- With the machine on and running press Timer and then the Timer/Temp
Adjust buttons (
▲▼
) to select the number of hours you would like the unit to run until it automatically shuts
off. The green timer LED will remain lit.
Timer mode b) Auto Turn On
:- Switch the machine on using the Power button so that the machine is
running and the desired mode is selected. Press the power button again to put the machine into stand-by
mode. With the machine in stand by mode, press the Timer button and then press the Timer/Temp Adjust
buttons (
▲▼
) to select the number of hours until it is required for the machine to start up automatically. The
green LED will continue to flash and the display will show the time set.
Timer/Temperature Adjust buttons
In Cooling or Dehumidifying mode, the temperature can be manually set by pressing the Timer/Temp Adjust
buttons (
▲▼
) between the limits of 16° to 32°C as shown in the display panel. This cannot be done in Fan
mode or heating mode. The default setting is room temperature. After 15 seconds the display will revert
back to room temperature.
IMPORTANT
When the appliance is in Cool or Dehumidifier mode, most moisture will be vented out through the vent pipe.
However, in certain circumstances some condensation may collect in the water tank at the bottom of the
chassis. When this tank is full, the “water full” indicator (
) will illuminate (red) and the appliance will stop
running. The appliance should then be unplugged from the supply socket and the rubber plug in drain port at
the lower rear
of the machine should be pulled out to drain the water into a suitable container. Alternatively,
move the appliance to a suitable place to drain the water.
Note: When the water full light
(
)
is on, the water should be drained out. If
the water is not drained out, the appliance will not operate.