Installation of the Indoor Unit
Note:- With all the various methods of installation detailed below it is important
to ensure there are no kinks, twists or sharp bends in the umbilical cord.
Method 1
The umbilical chord cord can pass though a partly
open door or window.
Note
The rear of the indoor unit must be spaced away from
curtains and drapes by at least 10cm.
Method 2
The plastic frame
(supplied) can be fitted into a
suitable cut-out in the window frame.
The umbilical cord can then be passed though the
plastic frame.
Note
When the air conditioner is stored away the blanking
cap attached to the plastic frame should be fitted in
place to blank off the aperture.
Method 3
(S
emi-permanent installation)
The umbilical cord can be passed through a hole in
the wall. If this method is chosen, the hole should be
fitted with the plastic frame supplied and the umbilical
cord should be disconnected* and then passed
through the frame/wall.
*See the section entitled “Disconnection
and Connection”.
Note
If you are not happy about disconnecting and re-
connecting the umbilical cord, request the help of a
local service engineer.
Soap suds should be used to check for refrigerant
leaks after re-connection.
When the air conditioner is stored away the blanking
cap attached to the plastic frame should be fitted in
place to blank off the aperture in the wall.
