13
Qualified personnel must have extensive experience
with and a working knowledge of:
For more information on suitable protective clothing
and safety gear refer to the safety data sheet of the
fluid in question.
pertinent rules and regulations concerning
handling hazardous substances
DANGER
Risk of bruises if the equipment or
component parts fall down.
Use suitable lifting gear when moving
or lifting the equipment and/or
component parts.
Make sure that the equipment cannot
topple over.
Make sure that nobody is standing
below the lifted equipment.
special regulations for handling the hazardous
substances encountered on site
using the required personal protective
equipment (PPE) and clothing
CAUTION
Environmental damage may be caused by
poisonous fluid residues.
Before disposing of the equipment
make sure that it is clean and free of
fluid residues.
For the disposal of all materials
observe the pertinent legal regulations
concerning waste disposal.
Detach the equipment connections from the
pipes.
Unfasten the lugs from the supports.
Place the equipment on a suitable surface.
Remove all residues from the equipment.
Store the equipment as described on page 8.
For the disposal of all residues observe the
pertinent legal regulations concerning waste
disposal.
Re-using equipment after storage
Observe the following instructions if you want to
remove the equipment and use it again somewhere
else:
Removing the equipment
DANGER
Personnel working on pipes are exposed to
safety risks and may suffer severe injuries,
poisoning or even loss of life.
Make sure that no hot or hazardous
fluid is in the equipment or the pipes.
Make sure that the pipes upstream
and downstream of the equipment are
depressurised.
Make sure that the installation is
switched off and protected against
unauthorised or unintended activation.
Make sure that the equipment and the
pipes have cooled down to room
temperatures.
Wear protective clothing that is
suitable for the fluid and, if necessary,
wear protective gear.
Make sure that the equipment is free of any
fluid residues.
Make sure that all connections are in good
condition and leak-free.
Use the equipment only for its intended purpose
and the service conditions for which it was
specified.
