GESTRA SPECTORcontrol II, Оригинальная инструкция по установке

Страница: 11 / 28

11
In control cabinet: Installing SPECTOR control
Dimensions Spector control
Installation in control cabinet
SPECTOR control is designed to be installed in the control cabinet by means of the fixing frame and
the integrated stud bolts at the rear panel. SPECTOR control can be used with ambient temperatures
up to max. 50°C. Note that direct sun light (UV light) reduces the lifespan of the LCD display. Install the
SPECTOR control as follows:
n
Unscrew the fixing nuts and remove the fixing frame.
n
Insert the supplied seal into the front panel slot.
n
Push the SPECTOR control equipment from the front into the front panel cut-out.
n
Push the fixing frame back onto the stud bolts. To secure the equipment in place use the four fixing
nuts. Make sure the nuts are tightened evenly from the rear until the front frame is flush with the front
panel all round .
Fig. 3
Front panel cut-out
287,0
321,0
329,0
196,
0
229,
8
238,
0
5,5
135.0°
The thickness of the front panel
must not exceed 5 mm.
- continued -
- continued -