21
Commissioning, fault indication and troubleshooting
For additional information on commissioning procedures and troubleshooting refer to the installation
manual of the level switch NRS 1-50.
Removing and disposing of the level electrode
Removing and disposing of level electrode NRG 1..-50
1. Loosen screw
q
.
Fig. 22
2. Detach upper part of the terminal box
s
from the level electrode.
3. Before removing the equipment make sure that is is neither hot nor under pressure.
For the disposal of the equipment observe the pertinent legal regulations concerning waste disposal.
If faults occur that are not listed above or cannot be corrected, please contact our service centre or
authorized agency in your country.
Danger
When loosening the electrode steam or hot water might escape!
This presents the risk of severe scalding all over the body!
It is therefore essential not to dismantle the electrode unless the boiler pressure is
verified to be 0 bar.
The electrode becomes hot during operation.
Risk of severe burns to hands and arms.
Before carrying out installation and maintenance work make sure that the steam trap is
cold.
Removing and disposing of level electrode NRG 1..-50F
1. Loosen screws
b
and remove housing cover
d
.
Fig. 13, 14
2. Unplug connecting cables from terminal strip and pull cables out of the cable gland.
3. Before removing the equipment make sure that is is neither hot nor under pressure.
For the disposal of the equipment observe the pertinent legal regulations concerning waste disposal.
Содержание NRG 111-50
Страница 22: ...22 For your Notes ...
Страница 23: ...23 For your Notes ...