Gestetner DSc38, Руководство по установке

Страница: 38 / 82

Setting Up
30
2
G
Keep pressing the Memory Unit
down until it clicks into the
locked position.
H
Adjust the Controller Board to the
top and bottom rails, and push in
slowly until it stops.
Insert the Controller Board firmly
by pushing the left area as shown
in the illustration.
I
Tighten two screws to fasten the
Controller Board back into its
original position using provided
screwdriver.
Note
❒
Be sure to return the provided
screwdriver to its original posi-
tion on the inside of the front
cover.
Note
❒
After finishing all installation
for printing, you can check
whether the Memory Unit is in-
stalled properly. Print the Con-
figuration Page from the "List/
Test Print" menu. If it is in-
stalled properly, you will see
the memory capacity for "Total
Memory".
❒
If the Memory Unit is not in-
stalled properly, reinstall from
step
A
. If you cannot install it
properly even after reinstalla-
tion, contact your sales or ser-
vice representative.
Reference
See P.68 “Test Printing” .
ZDJP029J
ZDJP030J
ZDJP801J
ZDJP031J