Gesipa PowerBird Pro Gold Edition, Руководство по эксплуатации с перечнем запасных частей

Страница: 18 / 160

18
GB
2.5 Safety instructions
Caution:
The following safety rules must be observed for adequate protection against electric
shocks, injuries or fire hazards:
• The blind riveting tool should be used exclusively to set blind rivets!
• Do not overload the tool; work within the prescribed work capacity.
• Never use the blind riveting tool in a humid or wet environment or close to inflammable
substances or gases. Risk of explosion!
• Ensure that the battery is properly secured in the grip.
• Remove the battery when the blind riveting tool is not in use and for repair/servicing
operations.
• The battery may only be charged in the temperature range between 0 °C and +55 °C.
• Do not use the blind riveting tool as a hammer.
• The blind riveting tool should be stored frost-proof and dry, in a locked room and out of
reach of children.
• When working with the tool, always wear protective goggles. Personal protection like
clothes, gloves, safety helmet, non-slip shoes, ear protection and anti-fall protection are
highly recommended.
• The air inlets for the motor should not be obstructed. Do not introduce anything into them.
• When setting the blind riveting tool down, make sure that it cannot fall.
• Use only genuine spare parts for repair.
• Repair work must be carried out by skilled workers. In case of doubt, always send the
blind riveting tool back to the manufacturer.
• Do not use the tool outside of riveting holes! The blind rivet could be ejected from the
tool! Never turn the tool towards yourself or towards another person!
• The mandrel container (H) must be mounted on the blind riveting tool tool during opera-
tion.
2.6 Starting procedure
• Insert fully charged battery in correct position into housing.
• Select correct nosepiece (A) according to table 2.4.
• To screw in the nosepiece (A), activate the switch (G) and proceed until the stop position
has been reached at the back.
• Then remove the battery. Screw in the nosepiece (A) and tighten it using the wrench
provided. Put the battery back in and activate the switch (G).