10
ESC
ENTER
P274B
ESC
ENTER
P274C
ESC
ENTER
P274D
I
II
P295E
ESC
ENTER
P274F
ESC
ENTER
P274G
Total opening radio code programming
P1
(with RSD receiver only,
C801
)
If a receiver other than RSD
is used, see the
corresponding instructions.
Select the option
C801
(RSD receiver) before
starting programming.
Pedestrian opening radio code programming,
P2
(with RSD receiver only,
C801
)
This procedure is the same as for total opening, but using parameter
P2
instead of
P1
.
1
Press ENTER, with the
display showing
rSXX
(
rS
º
Â
8
,
rS
º
â
8
,
rS
8º
@
,
rS
8º
?
, etc).
ESC
ENTER
P274B
ESC
ENTER
P274M
ESC
ENTER
P274N
ESC
ENTER
P274O
ESC
ENTER
P274P
P274Q
ENTER
ESC
Open/close programming (
P3
)
11
Start closing by pressing the
transmitter, ST1 or ^.
12
Start slowdown by pressing the
transmitter, ST1 or ^.
13
Wait for it to come to a stop at the
end of travel.
Once programming is complete,
the parameter
A6XY
is shown,
indicating the suggested
currents for normal speed (
X
)
and fast speed (
Y
). This can be
modified if required.
1
Press ENTER, with the
display showing
rSXX
(
rS
º
Â
8
,
rS
º
â
8
,
rS
8º
@
,
rS
8º
?
, etc).
Before programming, carry out
an opening and closing
movement at normal and slow
speed in order to detect the
corresponding currents
(parameter
A6XY
).
8
Start opening by pressing the
transmitter, ST1 or ^.
9
Start slowdown by pressing the
transmitter, ST1 or ^.
10
Wait for it to come to a stop at the end
of travel.
Pedestrian opening
is programmed using the parameter
F3
(see “Complete programming chart”).
14
15
ESC
ENTER
P274S
P274U
ESC
ENTER
D295A
Clutch adjustment
1
Insert the Allen key (1) in the housing (2).
2
Turn the Allen key until the notches (3) and (4) face each
other.
3
Insert a screwdriver in the notches (3) and (4) in order to
immobilise the transmission and adjust the clutch by turning
the key (1). Turning clockwise increases the power, whilst
turning anticlockwise decreases it.
Torque adjustment, respecting the maximum closing
forces set out in Standard EN12453:2000. Make the
measurements as described in Standard EN 12445:2000.
4
If the control panel has torque adjustment (PM), set it to the
maximum.