P.34
P.35
Positioning and installing the appliance
2g Fit hinge C and support L on the left side. (The hinge cover H, must be refitted at the end of installation).
2h Refit the middle support L on the right side.
2i Refit the lower door.
2l Insert pin P and spacer D.
2m Remove the door opening/closing elements S and reassemble them on the opposite side.
When installing the appliance, remember the following:
A Do not install it near to sources of heat such as heaters, radiators, cookers, etc. or in direct sunlight.
B Make sure that during the automatic defrost, any water on the back wall of the compartment runs into the
drain channel.
C After the appliance has been placed in its fi nal position, leave it for about an hour before connecting it to the
power supply.
D Make sure that the appliance is working properly before placing any food in it.
WARNING: DO NOT INSTALL THE APPLIANCE NEAR TO ANY HEAT SOURCES AND LEAVE A GAP OF AT
LEAST 5 CM ABOVE IT.
INSTALLATION IN THE TALL UNIT HOUSING
3 The dimensions of the tall unit housing must correspond to those reported in the figure.
3a Insert the appliance in the housing against the side panel adjacent to the opening. Check that the side of
the appliance is inset 53 mm in the unit.
3b Adjust the foot until the top panel is not in contact with the unit.
3c Anchor the upper part of the appliance, using the screws supplied, inthe pre-drilled panel over the front
fascia.
Positioning and installing the appliance