P.32
P.33
Positioning and installing the appliance
Positioning and installing the appliance
Removing the transport ptotection devices
Check that the appliance is undamaged.
The retailer must be informed of any damage to the appliance within 24 hours of delivery.
1 Remove the protection from the door gasket.
The protection is used to protect the gasket during transport.
The protection must be removed in order to ensure that the door seal functions correctly.
To remove the protection, lightly pull one end while rotating it outwards.
2 Remove the glass shelf locking devices.
These plastic elements prevent the shelves from moving during transport.
To remove the shelf locking devices, proceed as follows:
a) Grasp the plastic locking device and rotate it until it comes away from the shelf.
b) Remove the locking device by pulling it outwards.
Reversing the door opening
1 Once the appliance has been unpacked, check that the mains voltage is the same as that indicated on
the rating plate.
2 If the door opening direction is as required, go to Point 3.
Otherwise, reverse the position of the hinges.
To do this, carefully place the appliance on its back.
Use spacers to prevent crushing the condenser pipes and damaging the compressor unit.
2a Remove the lower hinge pin P and the distance spacer D.
2b Remove the lower door.
2c Slide off hinge cover H; remove the middle hinge B, then free the upper door.
2d Remove the upper hinge pin K and fi t it to the opposite side.
2e Remove the central support L.
2f Refi t the upper door.