P.7
安裝說明
Installation Instructions
安裝前注意
安裝必須使用原廠配件。若不按指示方法安
裝及使用而引致任何損壞，本公司概不負責。
安裝工作應由專業持牌水電技術人員負責。
Pre-Installation Notice
Installation should be done by a licensed
technician using the supplied parts. German Pool
is not responsible for any defect or damage
caused by incorrect or unauthorized installation.
Positioning
Position water heater near water tap / point of use
in order to minimize heat loss. For wall-mount style,
appropriate anchor screws must be used and wall
should be strong enough to withstand the weight
of water heater. Keep a minimal distance between
wall and water heater.
Connecting Inlet and Outlet Pipes
The diameter of piping is ½″ BSP. Make sure there
is no leaking at the joints. Turn on hot water tap
to fill up the inner tank until water flows from the
shower head. Turn off hot water.
掛牆定位
先將熱水器背板以膨脹螺絲安裝於承重的牆壁
上，然後將熱水器背部凹孔扣在背板上，並調
整至緊貼牆壁及保持垂直為佳。花灑頭插座以
膨脹螺絲安裝於適當位置上。
水喉接駁
水喉管件直徑為1/2"英吋，接駁妥當後應試看
接駁位置有否漏水，妥當後即可將有紅點之熱
水掣打開注水，直至花灑頭噴水即表示內膽經
已注滿，並可將熱水掣關好。
!
特別注意
!
ATTENTION