P.19
P.18
1. Open/close the door
Hold the door grip to horizontally pull out or push in the door. Do not apply
brute force.
2. Tableware arrangement
Vertically place the clean and dry tableware on the dish rack. The spacing
between the dishes should be sufficiently wide, otherwise the disinfection and heat drying result
will be affected.
3. Auto power off protection
Upon opening the drawer, the sterilizer enters inactive mode and all functionalities will be
suspended. Only by closing the drawer will resume operation.
4. Function Key
Operating Instructions
System Initialization:
Make sure the appliance is properly installed in place. Close the drawer before connecting it to AC
source. Plugging into the socket will emit a ticking sound, indicating the power is on and the machine
enters standby mode.
Disinfection function:
On standby mode, press the “Disinfect” button. The corresponding indicator lights up and the timer
reads 90:00. The disinfection duration can be set within 5 seconds. Press the button once again,
the timer reads 60:00. Pressing 3 times the timer reads 30:00. The display turns off upon the 4th
press. After setting the timer, if no other instructions are given within 5 seconds, the sterilizer will start
running. When the timer ends at 00:00, disinfection is complete and 16 ticking sounds will be emitted.
Heat-Dry function:
On standby mode, press the “Heat” button. The corresponding indicator lights up and the timer reads
90:00. The heat-dry duration can be set within 5 seconds. Press the button once again, the timer reads
60:00. Pressing 3 times the timer reads 30:00. The display turns off upon the 4th press. After setting
the timer, if no other instructions are given within 5 seconds, the sterilizer will start running. When the
timer ends at 00:00, heat-drying is complete and 16 ticking sounds will be emitted.
Smart mode:
On standby mode, press the “Smart” button. The corresponding indicator lights up and the timer reads
60:00. If no other instructions are given within 5 seconds, the sterilizer will enter the Auto mode. When
the timer ends at 00:00, the disinfection is complete. After a short while, the device will enter the
standby mode with the timer starting to count from 45:00 to 00:00. Then the heat-dry function will be
activated with the timer starting to count down from 60:00. When the timer ends at 00:00, heat-drying
is complete and 16 ticking sounds will be emitted.
Integrated functions:
On standby mode, press the “Disinfect” button to set the timer. Then quickly press the “Heat” button
within 5 seconds to integrate the disinfection and heat-dry function. Reversing the sequence of
pressing the 2 buttons will yield the same result. The timer can be set at either 90, 60 or 30 minutes.
When the sterilizer runs on the integrated mode, the disinfection function will precede the heat-dry
function. When disinfection is complete, the sterilizer will enter standby mode for 45 minutes before
proceeding to heat-dry operation. Disinfection and heat-drying cannot run simultaneously. The
“disinfect” indicator and “heat” indicator cannot light up simultaneously as well. To attain optimal
performance, a combination of 90-minute disinfection and 90-minute heat-drying is recommended.
Watch the video clip
Operating Instructions
Display
Smar t Key
Disinfect Key
Heat Key
