Gerber 2, Руководство пользователя

Страница: 16 / 57

10 CHAPTER 2
Getting to Know the GERBER MAXX 2
When loading the cassette, load the supply roll first. The memory reader button goes on the
front end of the roll (nearest the outside of the cassette). The cover has a label showing you the
foil path.
To load the foil in the cassette
1
Use a screwdriver to turn the three
cover screws 1/4 turn counterclock-
wise to loosen them, then lift off the
cassette cover.
2
Unwrap the new foil.
3
Slide the supply roll on the lower
cassette shaft.
4
Feed the leader and take-up roll
through the side of the cassette,
around the left roller, squeegee bar,
and lower right roller bar as shown
in the illustration. The dull side of the
foil will be facing away from the
cassette body.
5
Feed the take-up roll through the
trapezoidal window on the right side
of the cassette and over the upper
right roller bar.
6
Slide the take-up roll on the upper
cassette shaft.
7
Put the cover on the cassette and
tighten the three screws in the order
shown in the illustration. Turn the
screws 1/4 turn clockwise.
Note: If the foil folds over on itself, it will cause wrinkles on the print. To unfold the foil, push
the foil with your fingernail while rotating the take-up roll counterclockwise.
8
Before loading the cassette into the MAXX, ensure that the foil in the cassette is tight
and wrinkle-free from the supply roll to the lower right roller bar, and that the clear
plastic leader is not in or near the print area.