Operating Instructions Centrifuge Micro III
Gerber Instruments AG 7 Version 1.2 (03/2021)
4.
Unpacking/Device control
4.1
Unpacking
Make sure that the packaging has not been damaged.
Take the device and the inserts out of the packaging box.
Remove the remaining packaging material.
Remove the foam material in the centrifuge, see 6.1.
Place the device on a flat and dry substructure.
4.2
Device control
Control the centrifuge according to the following criteria:
Transportation damages
Other irregularities
If one of these criteria applies, immediately inform the forwarding agent or the supplier.
4.3
Control accessories
Check with the delivery note and your order if the scope of delivery is complete:
Type of centrifuge
Sleeves
Specific country cable
Fork key
Wire for emergency unlocking
Operating instructions
4.4
Avoiding damages on the device
Do not drop or disassemble the device.
The centrifuge must always be placed on a firm and dry substructure.
During transport from cold to warmer places, condensation water will collect inside the
centrifuge. It is important to allow sufficient time for drying before the centrifuge can be
used again.
