GEPRC SMART16, Руководство пользователя и инструкция по установке

Страница: 17 / 18

17 / 18
Pre-flight check:
In many cases, the cause of a crash is a lack of pre-flight check. For the sake of everyone’s
safety, we suggest that you conduct a thorough check before every flight. The steps are as
follows:
1. Turn on the transmitter and select the correct mode. Please confirm that the arming
switch on the transmitter is in the
“ disarmed ” position and the throttle is all the way down;
2. Please perform a physical inspection of the quadcopter for any visible damage. If there is
damage, please fix it first;
3. Please confirm the propeller is in the right direction and the propeller nut is locked tight,
otherwise there is a risk of crash;
4. Check LiPo battery voltage. A fully-charged LiPo should be about 4.2 volts per cell, or
about 12.6 volts for a 3S, or 16.8 volts for a 4S;
5. Please confirm the battery is securely attached to the aircraft by the strap. And
secure
the balance lead to eliminate a possibility of it being struck by the props;
6. Please check the flight area for any safety issues that might be present, such as people,
animals or other objects;
7. Verify that you have clean, strong video in your FPV goggles or screen. If you see
interference or you see another pil
ot’s feed, resolve this issue before flying;
8. Arm the quadcopter. Listen for the props , make sure they aren’t cutting into anything and
spinning freely;
9. At this stage, take off and enjoy flying.
Note: if you choose to fly close to water, please pay attention to the flight safety. It is difficult
and even dangerous to salvage a quadcopter when it falls into the water, and liquid damage
is not covered by the warranty.