GEPRC Pika, Быстрый старт

Страница: 8 / 15

Pika Manuals
- 8 -
Pika
2
、
Install Betaflight
-
Betaflight is an open source flight control procedures, specific introduction can refer to website:
https://github.com/betaflight
-
for the firmware required by PIka, please click the following link to download the firmware
name:
betaflight_3.2.5_OMNIBUSF4SD.hex
n
Latest version of firmware download website: https://github.com/betaflight/betaflight/releases
n
Be sure to download the
betaflight_3.2.5_OMNIBUSF4SD.hex
version. (You can select the latest version)
-
Install driver and ground station Betaflight
n
https://github.com/betaflight/betaflight/wiki/Installing-Betaflight
n
Ground station Betaflight - Configurator download address (you need to install Chrome browser) :
u
https://chrome.google.com/webstore/detail/betaflight-configurator/kdaghagfopacdngbohiknlhcocjccjao/re
views
3
、
Install the Receiver
-
If you choose the BNF version, you can Bind use the frequency and do not need to install the receiver again.
-
if you choose the PNP version, you will need to install the receiver on your own, Please click the following steps to
connect (such as the Frsky r-xsr receiver) :
n
note:must dismantle propeller for debugging.
n
Open the screws of the PIka, open the top vtx board, and you can see the flight control board on the second
floor.
n
The flight control board will have three welding locations: 5V,GND,S.Bus, Welding in the corresponding position
n
Finally, fix the receiver and lock the corresponding screw
n
As shown in the picture below: