6
To test the NFC Reader installation, touch a valid NFC Tag to the reader. The
green LED on the reader flashes twice and the GO device emits a single beep
when the tag is read. Repeat this step for each additional tag.
If a Driver ID Relay is installed and the feature is active in MyGeotab, you
must swipe a valid ID tag to activate the relay. Failure to activate the relay,
prior to use, causes the GO device to beep continuously and the electrical
connection, driven by the relay, remains inactive until a valid key tag is
swiped on the reader.
7
Navigate to installmygps.com to verify that the device is communicating. In
the space provided, enter your name, the company name, and the GO device
serial number — found at the bottom of the device. Click Log Install.
8
After you click Log Install, the webpage displayed the current
communication status of the device — in
GREEN
or
RED
text. If the device is
communicating, the status is displayed in
GREEN
text. If the device is not
communicating, the status is displayed in
RED
text.
Note:
If the device is not communicating, please ensure the GO device is
installed correctly and try again.
Copyright © Geotab Inc. 2015-2019 - All Rights Reserved | www.geotab.com | Rev 2.13 - 11/2019
® denotes a trademark of Geotab Inc., registered in Canada, the United States and other countries
3
