6
OPERATION
ENVIRONMENTAL PROTECTION
1. Fill only with a non-flammable degreaser or cleaning agent, to just below the level of the parts shelf.
DO NOT fill with flammable solvents such as paraffin, thinners, etc.
2. Open the lid, switch the pump on and hold the part to be cleaned under the nozzle, slowly rotate the
component until clean.
3. When clean, leave to drain on the tray or in a small component container until dry.
4. Switch off the pump and close the lid and disconnect the power supply.
5. Remove gloves and goggles, store safely.
Note: Any spillages should be mopped up immediately, so as not to cause a safety hazard.
IMPORTANT:
1. The Lid Stay incorporates a safety device in the form of a fusible link, which closes the lid in the
event of fire. The link is non-resetting and must be replaced should it be activated.
2. Clean the pump filter regularly, by sliding it away from the pump housing and rinsing it in clean
degreaser.
3. Do not allow the level of liquid in the parts washer to fall below the pump inlet, as damage to the
pump can result.
Do not dispose of this product or damaged components with general household waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and disposed of
appropriately.
One of the most damaging sources of environmental pollution is oil products. Never throw away used
oil with domestic refuse or flush it down a sink or drain. Collect any oil in a leak proof container and
take it to your local waste disposal site.
Through purchase of this product, the customer is taking on the obligation to the treatment,
recycling & recovery and environmentally sound disposal. In effect, this means that this product
must not be disposed of with general household waste. It must be disposed at a recognised
disposal facility.
