George Foreman GR80B, Руководство пользователя

Страница: 20 / 36

NOTE: When using this product for the first time, you may notice a
slight burning odor and a small amount of smoke. This is normal and
will dissipate in a short amount of time.
1. Use Cover Handles to lift open Cover.
2. Prepare food, Rotisserie Oven, and accessories as instructed in
“Preparing for Use.” If using the Rotisserie Bar, follow the instructions in
“Preparing for Use” under “Assembling the Rotisserie Bar” to install the
fully assembled Rotisserie Bar into the Rotisserie Oven.
3. Be sure Drip Tray is in place (See “Preparing for Use.”)
4. Plug the Rotisserie Oven into a standard, household electrical outlet.
5. The LCD Display will show: “0:00”.
Once the Rotisserie Oven is plugged in, you may operate the Motor
Button, the Light Button, or the Temperature (“TEMP”) Button.
NOTE: The Rotisserie Oven cannot begin heating and the SELECT but-
ton cannot be activated until the Timer is set and the ON/PAUSE Button
is pressed.
6. Press the Hour “H” Button to set the timer to the number of hours you
wish to cook the food (1-5 hours).
7. Press the Minute “M” Button to set the minutes.
8. Once your complete cooking time is programmed and the Timer is set,
press the ON/PAUSE button.
If the Motor was on the last time the machine turned off, the Motor will
immediately start as the Rotisserie Oven turns on. If the Motor is on, a
red LED will illuminate above the button and you will hear the motor turn-
ing the Rotisserie Bar.
If the Motor is off and you are using the Rotisserie Bar, press the Motor
Button to turn the motor on. As the food rotates around, check that the
food does not hit any of the Heating Elements. If you are using the Wire
Rack or Baking Sheet, you do not need to turn on the Motor.
9. When the Rotisserie Oven turns on, it defaults to heating the bottom front
and back Heating Elements (as represented by the LEDs above the Select
button). See the instructions marked “Select Button” under the
“Introduction” section of this manual for detailed information.
Press “SELECT” Button to choose Heating Elements. Each time you
press the button, an additional Heating Element is added. Then, when
you press the button again, it will revert back to its default setting (bot-
tom front and back Heating Elements).
Operation
20