6
Using your Steamer
• Place the steamer base on a stable surface.
• Place the turbo steam-ring over the heating element (largest diameter on the bottom).
This sits loosely.
• Fill the water reservoir up to MAX on the water level indicator with fresh, clean water.
NOTE: Only use clean, fresh water in your steamer. Do not use stock or any other liquids.
• Fit the drip tray on top of the water reservoir.
• Place the food to be steamed into the steamer basket/s.
TIP: Food cut into similar sized portions will cook at a similar rate.
• Stack the steamer baskets on top of the drip tray.
• Fit the lid onto the top steamer basket.
• Plug the steamer into a power outlet and turn the power on.
• Set the timer as required. (See ‘Setting the timer’ section)
• When time has elapsed, the steamer will switch to ‘Keep Warm’.
CAUTION: The steamer will be hot! Take care when removing the lid as steam will escape
and the steamer baskets and rice bowl will be hot.
• Once the steaming process has completed, press the ‘0/I’ button to switch the ‘Keep
Warm’ function Off.
• Using oven mitts or a cloth, carefully remove the lid from the steamer.
• Remove the baskets and place them on a heat resistant surface.
• Unplug the steamer from the power outlet and allow to cool before cleaning.
Setting the timer
• To begin steaming, push the ‘0/I’ button. The display will show ‘45’, flashing:
• Using the ‘+’ or ‘-‘ buttons, set the desired time you wish to steam for. Time increases and
decreases in 5 minute increments.
NOTE: If you set the timer to ‘0’ it will automatically switch back to the clock mode, and you
will have to start the process again. The maximum steam time you can set is 90 minutes.
• Once the desired time is set, wait 3-4 seconds and a beep will sound.
The beep sound indicates the steaming process has started. The indicator light will
illuminate red, the timer will begin to count down, and steam will start to rise up through
the steamer after a few moments.
• During the cooking process, check the food and adjust the cooking time if needed.
• To extend the cooking time, press the ‘+’ button to display the revised time on the display.
• To reduce the cooking time, press the ‘-’ button.
• When the set time has elapsed, a beep will sound and the steamer will automatically
switch to ‘Keep Warm’. The display will switch back to clock mode with the ‘Keep Warm’
symbol in the bottom right hand corner, and the indicator light will illuminate green.
Setting the clock
When you turn your steamer on, the display will show the time.
e.g.
• To set the time, press the ‘PROG and ‘0/I’ buttons simultaneously, then release. You will
hear a beep.
• Using the ‘+’ button increase the time in 10 minute increments, and using the ‘-‘ button,
decrease the time in 1 minute increments.
12:34
45
