GEONAUTE ONchannel 710, Руководство пользователя

Страница: 5 / 14

4
3 INSTALLATION
3.1 Installing the Battery
If the belt clip is installed,
remove it.
Observe the proper battery polarity orientation when installing batteries.
Incorrect positioning can damage both the batteries and the unit.
3.2 Installing / removing the belt clip
Installing the Belt clip
Î Î
Slide the belt clip into
the slot as shown in
figure.
INSERTING REMOVING
Removing the Belt clip
Î Î
Pull up the Belt
clip latch from the
ONchannel 710.
Î Î
While pulling the Belt
clip latch, push up the
belt clip as shown in
figure.
3.3 Charging the batteries
Important:
Read these Safety Warnings before you charge the batteries.
■ ■
When placing the ONchannel 710 in the charger, use only the power supply On Real
provided to this model ONchannel 710.
■ ■
Don’t try to recharge non-rechargeable batteries.
■ ■
Make sure the battery compartment cover is securely locked in place when you are
charging the batteries.
■ ■
Dispose of used batteries safely and in a way that will not harm the environment. Never
try to burn them or put them anywhere, they could get burnt or punctured.
■ ■
Don’t leave dead batteries in your ONchannel 710 units. They might leak if you do.
Î Î
Insert the small plug on the end of the mains adaptor into the power-in connection jack at the back
of the desktop charger.
Î Î
Plug the mains adaptor into a 240 VAC, 50 Hz main socket with the switch on the socket set to Off.
Î Î
Switch On the main socket.