23
ATTENTION :
No measure of heart rate when the electroluminescence function is activated or
the alarm sounds.
The stopwatch function
In stopwatch mode (CHRONO) :
Press
S1
to start the stopwatch.
Press
S2
to stop the stopwatch.
Press
S4
when the stopwatch has stopped to reset it to 0.
Intermediate time
In stopwatch mode :
Press
S1
to start the stopwatch.
Press
S1
to measure the intermediate time (the letters CHR flash to indicate that
the stopwatch is running). The intermediate time is displayed for about 10 seconds,
and then the display returns to the current stopwatch value (attention, the values
cannot be saved in memory).
Press
S1
to measure the following intermediate time.
Press
S2
to stop the stopwatch (
CHR
stops it from flashing).
"Training report" function :
If the "
zone Hr
" function is activated (On)after stopping the stopwatch, the watch
displays a training report. The following information is displayed sequentially, each
for 5 seconds. (You can also press
S2
to scroll the information) :
- Overall time
- Average heart rate
- Time spent in heart rate zone
- Calories burnt
ATTENTION :
If the watch does not detect any cardiac signal when it enters the stopwatch mode,
only the duration of the stop watch measurement is displayed when the stopwatch
is stopped.
5 - Alarm mode (ALRM)
S1 :
Activation / deactivation of the alarm
S4 :
Enter / leave settings mode
S2 :
Activation / deactivation of the alarm
S5 :
Electroluminescence
S3 :
Go to time mode
Set the alarm
In the Alarm Mode (
ALRM
), press
S4
for 3 seconds until the numeral for the hours
flashes.
Press
S1
or
S2
or increase or decrease the numeral for the hours. Hold down to
scroll the numerals rapidly.
Once the correct value is indicated, press
S3
to set the numeral for the minutes
that is flashing.
12:30
03
1013
T1
WE 4
P
mBar
60
22:01
ACC 70
M
69
8:00
ON
T1
AL-1
ALTI
ALTI
DATA 02
((
•
))
69
8:00
ON
T1
AL-1
3.70
LAP 02
LAP
2.49
ALTI
DATA 02
((
•
))
S3
S5
S2
S4
S1
A
07:00
ON
