Installation procedure
1
Wet the sensors with water or a water-based conducting gel to ensure
good contact.
2
Introduce one rib of the elastic into one of the holes on the belt
provided for this purpose.
3
Attach the belt around the chest, then position
the belt just below the pectoral muscles with
one of the sensors under the heart and the
other under the right pectoral.
4
Adjust the length of the elastic so that it holds
firmly but is still comfortable. The belt must not move
around if you jump or move your arms.
5
Check the positioning of the belt by bringing it
to 50 cm from the watch. The heart rate
should flash on the display. If it does
not flash normally:
- reduce the distance between the belt
and the watch
- adjust the position of the belt and wet
the sensors well
- check that the batteries are good, especially
in the belt
- go to cardio mode (procedure in paragraphs 6 and 7)
and press
S1
to test the connection
ATTENTION :
Avoid positioning the sensors in areas that are too hairy.
In cold and dry climates, the belt may need several minutes to function correctly.
This is normal because sensors need a film of sweat to ensure contact with the
skin.
When it first begins measuring, the watch may indicate very elevated values for
about for about 20 seconds. This is because the algorithm is initializing.
The display will stabilize at correct values after this interval of time.
Take precautions when fixing the elastic strap in the hole of the belt provided for
this purpose. Maintain the ergot by placing your finger behind the belt.
Navigation system
The CW600.T has 4 functioning modes: the hour, cardio, stopwatch and alarm
modes. You go from one to the other by pressing S3.
Note: By pressing S3 for 3 seconds in any mode, you will return directly to the Time
mode.
Explanation of each mode
19
Sensors
Sensors
TIME PULS CHRONO
ALRM
Time mode
Cardio mode
Chrono mode
Alarm mode
S3
S3
S3
S3
