Genvex Vanvex Optima 180, Руководство пользователя

Страница: 3 / 12

3
Optima 180
1. Users guide
Optima 180 AC comes with a factory setup, which
enables an immediate start of the unit. The factory
setup is basic and must be adjusted to the operational
requirements and demands of the individual home, in
order to obtain the optimum operating benefit from the
unit.
1.1 Use
Users menu
The value of a menu item is shown when pressing the
key/keycombination below. The value may be changed
with the arrows when the key/keycombination is held
down simultaneously. The control will return to standard
indication if no buttons have been pressed for app. 15
seconds.
P1: Level
The level key is pressed
With this key, it is possible to switch between:
standby, automatic operation, constant operation
and timer controlled constant operation. (Level 0,
level 1, level 2, level 3).
Level 0: The heat pump is now turned off and the
control is active.
Level 1: The fan only runs when domestic water
is heated.
Level 2: The fan also runs after the compressor
has stopped, providing extract to the home.
Level 3: The fan runs in a chosen period of time
- before it switches back to normal operation.
P2: Electric element ON
The electric element key is pressed
The heat pumps are supplied with an extra
heating element for heating the domestic water.
With this signal key, it is possible to switch on
the electric element for heating the domestic
water. By adjusting the set point to 1, the electric
element will turn on whenever needed. By
adjusting the set point to 0, the electric element
will not turn on if needed. At outdoor temperatures
below 0°C it is an advantage to use the electric
element.
Factory setting: 0
P3: The operating thermostat is pressed
The required domestic water temperature may
be set between 0 - 55 °C, which is heated by the
heat pump.
Factory setting: 52,0°C
P4: Stop defrosting
The level and operating thermostat buttons
are pressed simultaneously
As a standard setting, the defrosting period
ends when the temperature has reached 10 °C.
During extraordinary operating conditions, it may
be necessary to change this temperature. The
temperature may be adjusted between 0-25°C.
Factory setting: 10,0°C
P5: The electric element
The electric element and the operating
thermostat keys are pressed simultaneously
The domestic water temperature may be adjusted
between 0 - 65 °C. The electric heating element
solely heats the top half of the container, while
the heat pump still heats the lower half of the
container.
Factory setting: 50,0°C
Display indication
It is possible to view various temperatures in
the display, by pressing the arrows until the
required temperature has been shown. After
app. 5 seconds, the temperature is shown.
The temperature is shown for app. 30 seconds
until the display returns to standard. Following
temperatures may be shown:
T4: Extra sensor for free use or forced operating
input
T5: Pre cooling surface
T6: Cooling surface
T7: Domestic water top
T8: Domestic water bottom
T9: Solar collector temp (accessory)
1.2 Altering of the operation data
Usually, the display shows the water temperature.
Press (arrow up) and (arrow down) simultaneously for
app.10 seconds in order to enter the operating menu. The
+
+