Suggested Owners Manual Text for Auto-Dimming NVS
®
Mirror with Z-Nav™ and HomeLink
®
Operating HomeLink
®
To operate, simply press and release the programmed HomeLink
®
button. Activation
will now occur for the trained device (i.e. garage door opener, gate operator, security
system, entry door lock, home/office lighting, etc.). For convenience, the hand-held
transmitter of the device may also be used at any time.
Reprogramming a Single HomeLink
®
Button
To program a new device to a previously trained HomeLink
®
button, follow these steps:
1. Press and hold the desired HomeLink
®
button. Do NOT release until step 4 has
been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position the
handheld transmitter 1 to 3 inches away from the HomeLink
®
surface.
3. Press and hold the handheld transmitter button. The HomeLink
®
indicator light will
flash, first slowly and then rapidly.
4. When the indicator light begins to flash rapidly, release both buttons.
5. Press and hold the just-trained HomeLink
®
button and observe the red Status
Indicator LED. If the indicator light stays on constantly, programming is complete
and your new device should activate.
Erasing HomeLink
®
Buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink
®
buttons until the indicator light begins to
flash-after 20 seconds.
2. Release both buttons. Do not hold for longer than 30 seconds.
The
Integrated HomeLink
®
Wireless Control System is now in the training (learn) mode
and can be programmed at any time following the appropriate steps in the Programming
sections above.
FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3
This device complies with Part 15 FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Warning
The transceiver has been tested and complies with FCC and Industry Canada rules.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the device.
NVS
®
is a registered trademark and Z-Nav™ is a trademark of the Gentex Corporation,
Zeeland, Michigan. HomeLink
®
is a registered trademark owned by Johnson Controls,
Incorporated, Milwaukee, Wisconsin.
