Page 5 of 11
Revision A
550-0426
7. Route harness to vehicle connection wires.
a) Using fish-wire, route harness from base of A-pillar through dash
and into connection wire / fuse block area.
(Fig. 17)
8. Attach wire tap to vehicle wire marked IGNITION.
a) Center blade of wire tap on IGNITION wire and close wire tap
with pliers.
(Fig. 18)
b) Ensure both halves of wire tap are closed completely and
locking tab is engaged.
9. Connect auto-dimming mirror harness switched power wire to
vehicle wire marked IGNITION.
a) Insert spade terminal on auto-dimming mirror harness wire into
the wire tap on the vehicle wire labeled IGNITION.
(Fig. 19)
10. Connect auto-dimming mirror harness ground wire.
a) Locate a ground bolt near connection / fuse block area and
remove.
NOTE:
Bolt locations may vary but common locations are in the
kick plate / cowl cover area or parking brake release
handle.
b) Install ring terminal of harness over bolt and reinstall.
(Fig. 20)
NOTE:
If auto-dimming mirror is not equipped with outside temperature
feature, skip to section 5 "Secure Harness Wires."
1. Mount temperature sensor.
a) Remove splash guard panels if necessary to gain access to the
area behind front bumper.
b) From inside engine compartment, route sensor end of
temperature harness down in front of radiator to area behind
front bumper.
(Fig. 21)
c) Locate a mounting area for the temperature sensor in vehicle
grille or bumper opening. This area should be as far away from
the front of the radiator as possible while still allowing for free
airflow around sensor.
(Fig. 22)
4
(Optional) Temperature Sensor Installation and Routing
19
22
21
20
18
17
