Page 7 of 11
Revision A
550-0426
d) Pull harness through grommet and into passenger compartment.
(Fig. 29)
e) Remove tape from harness.
f) Inside engine compartment, leave extra wire for drip loop in front
of grommet.
g) Apply silicone sealant to grommet where harness wire passes
through, to seal opening.
5. Route temperature harness to auto-dimming mirror.
a) Route harness through dash up to base of A-pillar.
(Fig. 30)
b) Route harness up A-pillar.
(Fig. 31)
c) Route harness across vehicle headliner and down to
auto-dimming mirror.
(Fig. 32)
d) Conceal harness wires under optional wire cover if used.
6. Connect temperature harness to auto-dimming mirror connector.
a) Unplug connector from back of auto-dimming mirror.
b) Insert terminals from temperature harness into pins #6 and #7
of mirror connector.
(Fig. 33)
NOTE:
Temperature harness wires are not polarity sensitive
so either terminal can be plugged into either opening
on connector.
c) Plug connector back into auto-dimming mirror.
d) Ensure mirror has full rotation before proceeding to next step.
30
31
32
33
29
