Page: 8 of 16
Copyright © 2013 GenTent Safety Canopies, LLC – All Rights Reserved
V5 – July, 2013
1a) Rubber Pad Installation (if required)
Test fit the pad into the clamp:
- The pad goes on the inside rounded
parts of the clamp opening as shown
- Orient the pad so that the long side
aligns with the height of the clamp
- Test fit the pad inside the clamp
opening as shown.
Peel and Stick the pad into the clamp:
- Peel the backing paper from the pad – Take care when peeling the backing so the glue
does not come up with the paper backing. If this happens, restart the peeling at a
different corner.
- Orient the pad as in the test above and apply to the inside of the clamp.
- Repeat for the other side of the clamp.
- Repeat for each clamp requiring rubber pads
