11
www.gentecaustralia.com.au
*Regular service must be carried out on the product to avoid product failure.
Automatic ON/OFF
Wave ON/OFF
Hygienic/Flush
RUN TIME ADJUSTMENT
Before changing the run time, Select
the Mode option with the black
remote controller. Then, using the
Grey remote controller, Button 3
(increase) and Button 4 (decrease)
the run time.
Note:
To change the time between hygiene
flushes (6hours, 12hours, 24hours,
48hours) Use the black remote
controller 2 . To INCREASE the time
between hygiene flush use button
3. To Decrease the time between
hygiene flushes button 4 .
Remote Operation
When hands are in the sensor’s range, program
turns ON. Removing hands from the sensor’s
range will switch the sensor OFF. See Figure 1
Default is for Sensor to switch OFF after 2
seconds RUN; however this is adjustable with
the Grey remote controller 1.
Waving hands within the sensors range switches
the program to ON.
Waving hands again within the sensors range
will switch the sensor to OFF. See Figure 2
Pre-set run time is 15 seconds run, however
this is adjustable using the Grey remote
controller 1.
•
Hygiene flush is not activated by Default.
•
Hygiene flush can be activated by black
remote STS9005B2.
•
Hygiene flush run time is locked at 40
second run time. This run time cannot be
adjusted.
Figure 1
Figure 2
Functions
Grey Remote
Black Remote
STS9006
Adjusting
Controller
Set
Product
Type
Sensor Range and Time
Adjustment.
*Sensor Adjustment range
<100mm up to 200mm
Selection Mode
Button 1
Increase the sensor distance
( 1cm-2cm increments)
Activate Automatic ON/OFF
( 2sec run time)
Button 2
Decrease the sensor distance
( 1cm-2cm increments)
*Before using buttons 3 or 4,
First select the Mode (with the
black remote 2)
Activate Wave ON/OFF (15 sec run time)
Button3
Increase the run timing
Increase time between Hygiene flush
Button 4
Decrease the run timing
Decrease time between Hygiene flush
Button 5
Deactivate / Activate Sensor
Hygiene Flush on/off
