![background image](http://html1.mh-extra.com/html/genius/verifone-mx915/verifone-mx915_quick-start-manual_2213259002.webp)
Removing the Communications Module
Place Genius on the countertop and turn it over so the
bottom is facing up. Press the two flexible tabs and push
up until the communications module slides out.
With the module in hand apply pressure to the metallic
plate covering the green cable connection and slide it off
of the module. Gently lift the cable from the housing.
Running the Utility Cable
First, establish the path the utility cable will follow at your point of sale. Place the Genius CED on the countertop in the location
you desire, ensuring the CED is in a position facing the customers of this POS station. The Utility cable will already be connected
to the CED via the removable communications module. Typically the cable will be placed below and behind the countertop while
the CED is on top of the counter facing the customer. Please note the hob on the utility cable must be in close proximity to both
a power outlet and an open network slot. Once you are satisfied with this arrangement, it is time to begin connecting Genius. If
you need to remove the cable in order to run it through a countertop follow the instructions below.
The Utility Cable
The utility cable provides power to Genius. Therefore,
power must be supplied to the utility cable. With the utility
cable properly run to an area below or behind the counter-
top, locate an available power source.
With the power cable in hand, gently but firmly insert
the +12V end in to the labeled slot on the utility cable
as shown in the illustration. Then, insert the power cable
into the available power outlet.
+12V
Audio
USB
Ethernet
HOST
Once removed run the cable through your countertop
accordingly. When the cable is run, place the green end
back into the housing in the communications module and
fit the metallic plate on top. Re-insert the module into the
CED, making sure it clicks in place once fully attached.