Genius GE-BIN4, Руководство пользователя

Страница: 15 / 56

GE-BIN4 INSTALLATION
GE-BIN4 Section B-15
Powering up procedure
Once the GE controller is properly mounted on the wall and all modules are connected to
the terminal block, perform the following steps:
Adjust the Line Voltage Selection Switch
This switch is located on the bottom electronic board and adapts the GE-BIN4 to 115
VAC or 230 VAC line voltage.
Set the line voltage switch (115VAC/230VAC) inside the GE-BIN4 to the correct value
before powering up the GE-BIN4 control.
Verify all connections
Seal all cable entry holes.
Hermetically close the GE Controller
Close the front panel and the lower access cover.
Put the power on
Secure the front panel with a lock
GE Controller compatible modules
This is the list of all the compatible modules that can be connected with the GE controller
with a short description of their function.
Weighing module
 GE-FBT (Feed Bin Transmitter module that allow the GE-BIN4 to measure the bin
weight)
Lightning Isolator module

GE-LIM (Lightning Isolator Module that protects the GE-BIN4 against lightning)
GE computer interface
 Communication card (X1152 card inserted into the GE controller to communicate
with the computer interface)
 RF-IN2 Communication Module (Module inserted into the controller for a wireless
communication with the computer interface)
www.monitrol.com