background image

3

ENGLISH

Fig. 6

Fig. 7

Fig. 8

Fig. 5

2) Secure the articulated fitting of the operator to the rear

bracket by means of the supplied pins (Fig. 5).

Caution:

 before securing the operator on the rear

bracket, which has just been welded

,

 make sure its

temperature does not damage the articulated fitting.

3) Completely withdraw the stem up to its stop (Fig. 6).
4)  Rotate the operator stem half/one turn clockwise (fig. 6)

5) Fit the front bracket on the stem as shown in Fig. 7.

6) Close the gate leaf and, holding the operator in  a

perfect horizontal position, locate the front bracket

securing point on the leaf (Fig. 8).

7) Temporarily secure the front bracket on the leaf by

means of two welding points.

Note

: If the fitting cannot be secured firmly due to the

gate structure, a firm resting base on the structure is to

be created.

8) Release the operator and check manually if the gate is

free to open completely up to the mechanical stop limits

and if the leaf movement is regular and without any

friction whatever.

9) Weld the front bracket on the leaf (Fig. 8).

To do this, temporarily release the operator from the

fitting in order to avoid that welding slags damage it.

Note:

 We recommend to grease every fixing pin of the

fittings.

10) Carry out the installation of the second operator, if any,

repeating the above mentioned operations.

11) Install the enclosure and the control board keeping into

consideration the overall dimensions given in the

instructions.

6. START-UP

CAUTION: Before attempting any work on the system or on

the operator, always turn off power.

Observe points 10, 11, 12, 13, 14 of the GENERAL SAFETY

OBLIGATIONS.
Observing the instructions in Fig.3, lay the raceways and

make the electric connections of the control board to the

selected accessories.
Always separate power cables from control and safety

cables (push-button, receiver, photocells, etc...). To prevent

any electric noise whatever, use separate sheaths.
1) Program the control board according to your needs

observing the concerning instructions.

2) Switch on power to the system and check the condition

of the LEDs according to the table of the control board

instructions.

Отзывы: