8
Before you start, please make sure that the wall or ceiling is strong enough to withstand 3x
the weight of the camera. Please install the camera in the dry environment.
3.0 Product Installation
Lower Dome
Lock Screw
6
148
22
88 mm
89mm
Sponge
Mounting Base
Focus
Zo om
Rotation
0°~360°
Pan 0°~360°
Tilt 0°~75°
1. Loosen the screws to open the lower
dome and then loosen the lock
screw to remove the mounting base.
2. Attach the drill template to the place
where you want to fix the camera
and then drill 4 screw holes and 1
cable hole (if you want to route the
cables through the mounting base)
according to the drill template.
3. Route and connect the cables and
then secure the mounting base to
the ceiling or wall with screws.
4. Fix the camera to the mounting base
with the lock screw.
5. Three-axis adjustment. Before
adjustment, preview the image of
the camera on a monitor and then
adjust the camera according to the
figure below number 6 to get an
optimum angle.
6. Adjust the Focus and Zoom screw to
get a clear image (if your camera is a
fixed lens or motorised lens, please
skip this step).
7. Install the lower dome back to
the camera with the screws and
remove the protection film softly to
complete the installation.
