Genie Quietlift 2M, Руководство по эксплуатации и обслуживанию

Страница: 6 / 18

6
SECTIONAL DOOR
Check Step 4:
C
HECK
D
OOR
H
EADER
A
REA
NOTE
The header is a heavily reinforced section of the wall just
above the top of the garage door opening.
A Find vertical center line of door and header:
•
Close door.
•
Measure door width at top.
•
Mark a point at center of door and on header directly
above door. Draw a center line to connect points.
B Find Header Bracket mounting height ( Figure 4 ): (Do not attach
Header Bracket).
•
Raise door, watching top edge of door and stop door
when its edge reaches its highest point.
•
Measure distance
(“H”) from top edge of door to floor.
– For sectional doors,add 1" to “H”. Mark a point
on center line. Bottom of Header Bracket will be
installed here.
– For one-piece doors,add 7" to “H”. Mark this point on
center line. Bottom of Header Bracket will be
installed here.
HEADER
ONE-PIECEDOOR
HEADER
Figure 4 Find Highest Point of Travel
NOTE
•
For both types of doors:
– If the ceiling in your garage isso low that there
is not at least a 3" space above the Header
Bracket mounting point, contact aGenie Factory
Authorized Dealer.
•
If a door spring is in the way, place the Header
Bracket above the spring. Do Not move the door
spring.
C Check wall for a stud or a solid header at your mark: (If checking a
finished wall,a stud finder may be helpful).
•
If location is above Header,a 2" x 6" board must be
screwed to studs beside your mark with at least two Lag
Screws and Flat Washers (not provided).
•
Transfer your mark to new mounting board.
Check Step 5:
C
HECK
P
OWER
H
EAD
M
OUNTING
A
REA
Check ceiling or space above where Opener Power Head will be
mounted ( Figure 5 ):
120Volt grounded outlet
or wiring box within 3 feet of
Power Head.
11'
Door Center Line
Figure 5 Check Power Head location
A Measure from garage door center line toward rear of garage:
•
Approximately 11'.
B Find location of ceiling joist or trussabove where Opener Power
Head will be and estimate type and quantity of materials needed for
your installation (
Figure 6 ).
MOUNTINGEXAMPLES
Perforated Angle Iron
Conduit
Perforated Straps
FINISHED CEILINGS
Locate ceiling joists or trusses using
a stud finder or similar device.
Attach angle iron(not included) to
joists or trusses through finish
material using Lag Screws.
OPEN CEILINGS Straps and angle
iron may attach directly to joists
or trusses.
Figure 6 Mounting methods for open beam or finished ceilings