Genie GTH-5519, Руководство по обслуживанию и ремонту

Страница: 56 / 129

3-34 GTH-5519 Part No. 1272852
September 2016 Section 3 • Repair Procedures
7-2
Valve Coils
How to Test a Coil
A properly functioning coil provides an
electromagnetic force which operates the
solenoid valve. Critical to normal operation is
continuity within the coil. Zero resistance or infinite
resistance indicates the coil has failed.
Since coil resistance is sensitive to temperature,
resistance values outside specification can
produce erratic operation. When coil resistance
decreases below specification, amperage
increases. As resistance rises above specification,
voltage increases.
While valves may operate when coil resistance
is outside specification, maintaining coils within
specification will help ensure proper valve function
over a wide range of operating temperatures.
WARNING
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury.
Remove all rings, watches and
other jewelry.
Note: If the machine has been in operation, allow
the coil to cool at least 3 hours before performing
this test.
1 Tag and disconnect the wiring from the coil to
be tested.
2 Test the coil resistance using a multimeter
set to resistance (

). Refer to the Valve Coil
Resistance Specification table.
Result: If the resistance is not within the
adjusted specification, plus or minus 10%,
replace the coil.
Valve Coil Resistance
Speci
fi cation
Note: The following coil resistance specifications
are at an ambient temperature of 68°F / 20°C. As
valve coil resistance is sensitive to changes in
air temperature, the coil resistance will typically
increase or decrease by 4% for each 18°F / 20°C
that your air temperature increases or decreases
from 68°F / 20°C.
Description Speci fi cation
Steering modes selector valve,
3 position 4 way
12V DC with diode 5.6

Mechanical gear speed Selector
valve, 3 position 4 way
12V DC with diode 8.8

Forward/Reverse Selector valve,
3 position 4 way
12V DC with diode 8.8

Outrigger Selector valve,
2 position 4 way
12V DC with diode 8.8

MANIFOLDS